Laserdrw 41/16/2024 Networked device: LightBurn can't automatically configure a network-connected laser.If you run other software, like RDWorks, Easel, Carbide Create, AutoLaser, LaserCAD, etc, make sure that software is not running when you run LightBurn. Can't connect: Only one application can talk to your laser at a time.In the case of galvo devices, they have a LightBurn specific driver that needs to be used.Even if you don't plan to use it, they can include the necessary drivers that aren't included with LightBurn. Missing drivers: Install your laser-specific drivers and software.If LightBurn can't find your laser, it could be for a number of reasons: Next: Software walk-through for beginners See the Galvo Setup page for a step-by-step guide on completing the required steps. Select the location, enter your workspace size, and you're done. Galvo devices have a few more steps comparatively, where LightBurn will attempt to import the markcfg7 file from your EZCAD2 setup. Next: Software walk-through for beginners Galvo devices ¶ If you get it wrong, things may be backwards or upside down, but don't worry-you can easily change it later.Ĭlick 'OK' on the Devices page to exit after your laser has been added. This is the corner the machine moves to when looking for the homing switches after power up. If you have a DSP controller, the next screen will ask you for the machine origin location. Next: Connecting to the Laser DSP devices ¶ With some GCode devices, additional configuration of either LightBurn or the controller may be necessary. If you see Error: 9 in the console later, it means you've enabled this feature, but your machine isn't configured for homing. Nearly all GCode systems use the front-left corner as the origin.Įnable the homing on startup if your machine has homing or limit switches, otherwise leave it off. You may be asked where the origin of your machine is and if you want to home on startup. If you have one, click the appropriate button. If you have a GCode controller, you'll be asked if your machine is an X-Carve or Shapeoko because there are some specific settings that need to be configured for those machines. Is your laser a GCode, DSP, or Galvo device? What if it wasn't found? GCode devices ¶ In the above image, I have two lasers connected to my computer-the first, a GRBL controller on COM9, and the second-a Ruida DSP controller on COM3. LightBurn will list the devices it was able to recognize after a short scan: Make sure your laser is powered on, connected to your computer with a USB cable, and has completed any startup sequence it needs to, like homing. In the Devices page, click the 'Find My Laser' button, and you'll see this screen: Start by clicking the Devices button in the Laser window to open the Devices Page.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |